Solihull Council has approved the design of a 77-metre weathering steel footbridge carrying the Heart of England Way over HS2 north of Balsall Common, with a ramp, steps and two benches.

A 77-metre footbridge will carry the Heart of England Way over the HS2 line north of Balsall Common, after Solihull Council approved its final design on Monday.

The bridge takes Footpath M214, part of the long-distance walking route, across the railway’s Park Lane cutting. The site is east of the A452 Kenilworth Road, about 680 metres north of the village and 790 metres west of Berkswell.

The council approved the plans and specifications on 9 November, with three conditions (decision notice, PL/2026/01694/HS2DIS). The application came from HS2 Ltd through its contractor Balfour Beatty Vinci. Under Schedule 17 of the HS2 Act, the council approves the detailed design of works the Act has already authorised; it does not decide whether the bridge is built.

The bridge in numbers

HS2’s written statement to the council sets out the design (written statement, September 2026):

Feature Figure
Length 77m
Overall width 4.2m
Walking width on the deck 3m
Clear span over the railway 40m
Clearance above the cutting floor 11m
Parapet height 1.8m

The bridge is a steel arch, with the arch below the deck. The girders and parapets are weathering steel, which rusts to a brown finish and needs no paint. The parapets are perforated panels that turn fully solid at the centre of the bridge. The deck and approaches are surfaced in resin-bound gravel.

Getting on and off

The approach from the west is a gentle slope, with ground raised by no more than half a metre. The eastern side has a mix of steps and a switchback ramp, with the ground built up by up to two metres.

The ramp has a maximum gradient of 1 in 21 and is 1.8 metres wide, so the path stays usable for people who cannot manage steps. HS2 says the bridge closely follows the line of the existing path, so walkers will not have further to go once it opens.

Two concrete benches will sit at the top and bottom of the eastern stairs and ramp.

Why HS2 chose a steel arch

HS2 looked at three designs. An all-concrete bridge would have been the quickest and cheapest to build and needed little maintenance. It was rejected because of its larger carbon footprint and a narrow, enclosed deck.

The steel arch costs “significantly more” and takes longer to build, the statement says. HS2 chose it for its lower carbon footprint, its wider and more open deck, and because it was “the most befitting of the local landscape”. A third design, a steel truss, was ruled out for its effect on the landscape and higher upkeep.

What the council asked for

The approval comes with three conditions:

  • the bridge must be built exactly to the approved drawings and materials list
  • HS2 must get the council’s approval for the bird deterrent mesh around both abutments before it goes up
  • HS2 must get approval for the appearance and size of the two benches before they are installed

The council also sent HS2 separate comments on landscaping and other mitigation. Its decision notice reminds HS2 that it will need further council approval before the bridge is brought into use.

What it means for you

  • Walkers: while the bridge is built, the current line of Footpath M214 will be closed for about six months. A temporary diversion will run about 40 metres to the south for roughly 485 metres, adding about 280 metres to the walk, according to HS2’s statement. HS2 has not published dates for the closure.
  • Afterwards: the footpath will be permanently diverted over the bridge.
  • Questions: HS2’s Solihull community page carries contact details and local updates.